Filter by tags
Questions, Articles and Polls
2 Likes
·
1 Answer
A:
Unquestionably, the corrosion resistance is better using pre-painted metal than metal from a typical post-painted product. Due to the superior cleaning and treating of the strip during the coil coating process, the priming of both sides and the
... more
1 Like
·
1 Answer
A:
No. A coil cleaner that leaves a "shiny" surface may have removed some of the corrosion protection from that surface. This may reduce the durability of the evaporator itself. Also, the cleaner may leave a residue that is incompatible with Air
... more
2 Likes
·
1 Answer
A:
Efficiency is primarily determined by the distance between the power source and capture device, however, the shape may impact the efficiency. WiTricity uses validated models to predict the effects of distance, shape, and materials on the
... more
2 Likes
·
1 Answer
A:
Use one of the three following application methods: A. Remove Blower Motor, see applicable service manual i. Clean any debris from the plenum and evaporator surface. ii. Apply AirSept Cooling Coil Coating directly to the evaporator through the
... more
2 Likes
·
1 Answer
A:
We rarely get complaints of non-performance of the product. The few complaints that we received have generally been traced back to improper application technique. The three most common application mistakes are: Not taking the time to completely dry
... more
2 Likes
·
1 Answer
A:
The voice coil of a subwoofer is the coiled wire that is wrapped around the former, or cylinder inside the subwoofer. The two voice coil configurations allow for different wiring options. For more information on voice coils, please refer to our
... more
2 Likes
·
1 Answer
A:
It all depends on the condition of your existing coil springs, the amount of lift you are looking for and your load carrying needs. So if you are otherwise happy with your existing coil springs, aside from the ride height, and are looking for about
... more
2 Likes
·
1 Answer
A:
Some subs have dual voice coils. I would assume voice coil jumpers are short pieces of wire for the coils (in electronics work, a short piece of wire is typically called a jumper). You can make new ones easily, without soldering. Usually, voice
... more
2 Likes
·
1 Answer
A:
When you are wiring a dual voice coil sub you will need a DVC subwoofer, an amplifier, speaker wire and wire cutters. You can begin by stripping the insulation from the ends of the speaker wire.
... more
1 Like
·
1 Answer
A:
Answer Hi Joe, I seriously doubt it but it depends on what purpose you are using it for. There were some eye problems being caused by some brands of compacts but these were the high UV output designs that were involved. The manufacturers have been
... more
1 Next