Filter by tags
Questions, Articles and Polls
2 Likes
·
1 Answer
A:
They both help start your dryer, but an electronic igniter uses less energy because it is not constantly running.
... more
3 Likes
·
3 Answers
A:
If you use a harmonic balancer remover it'll work. But there is a steering wheel remover tool. You also have to remove a round clip after you pull the steering wheel and this clip has a spring behind it so you'll have to push down on it pretty hard.
... more
Did they make an after market Electronic Ignition to replace the Distributor Cap on a 96 S10 Blazer?
2 Likes
·
1 Answer
A:
There is not much information on the Distributor Cap of a 96 S10 Blazer. From our research it seems some people do replace them.
... more
1 Like
·
1 Answer
A:
By running a tight plug gap, you are making sure that the spark gets to the plug. If you run a wider gap than that with a mag, you may end up with the spark arcing to other objects inside the mag or crossfire between plug wires. The spark plug
... more
2 Likes
·
1 Answer
A:
An ignition interlock is a sophisticated system that tests for alcohol on a driver's breath. It is a device that requires a vehicle operator to blow into a small handheld alcohol sensor unit that is attached to a vehicle's dashboard. The car cannot
... more
1 Like
·
1 Answer
A:
Yes. We have conversions for these engines. We do not recommend doing this. This gets pretty expensive and can cost as much or more to convert to gas as the engine cost in the first place. These engines on a gas fuel mix are not successful unless
... more
1 Like
·
1 Answer
A:
Read More 4 degress BTC Read More The correct ignition timing for a 1964 chevy 230 cubic inch six cylinder: 4 degrees BTDC and located on the damper. Just in case you are not aware. Make sure the vacuum advance hose is disconnected from the
... more
1 Like
·
1 Answer
A:
The timing is to be set at zero TDC.The connector is on the passengers side under the hood against the fire wall.There might be a plastic cover over it.It is a tan wire with a black stripe.Sometimes it will be in the passengers side under the dash.
... more
1 Like
·
1 Answer
A:
When replacing a distributor for any reason whether it is a malfunction or a modification, the timing must always be set back to factory or modified specifications. Timing effects how the car starts, idles and runs at various throttle settings. It
... more
2 Likes
·
1 Answer
A:
We don't actively encourage the use of self-testers, which can give a false impression of your alcohol level because alcohol may still be being absorbed after the self-testing device is used. We prefer people to adhere to principle of no alcohol
... more
1 Next