...

Filter by tags

Selected Tags


Questions, Articles and Polls

1 Like · 1 Answer
A:
Yes, you will need a waste overflow and drain kit and a Roman tub faucet with or without a hand shower. ... more
2 Likes · 1 Answer
A:
The color is up to you, but it must be an 18 to 20 inch and not the 12 inch used on regular tubs. My contractor is ready to install my Izzi whirlpool bath and informed me that I need to select a Roman tub faucet. I want a hand shower, but dont have ... more
1 Like · 1 Answer
A:
No you dont, but some people install them anyway to prevent small children from activating the whirlpool and possible damaging the motor by running it dry. ... more
2 Likes · 1 Answer
A:
For a 1 or 11/2 HP pump, 110v. Pumps require a dedicated 110v 20 amp GFCI protected electrical circuit. The optional in-line heater requires an additional 110v 20 amp GFCI protected electrical circuit. The optional blower air bath System requires a ... more
2 Likes · 1 Answer
A:
Any non-abrasive liquid cleaner off the shelf may be used. Be sure to read the label and follow the cleanser's recommendations. Do not use harsh abrasives like Comet, Ajax, Bon Ami, etc. as they will harm and dull the finish of your unit. ... more
1 Like · 1 Answer
A:
It is possible that the pump was run dry and is damaged. If the motor is run without water for 15 minute or more, the pump wet end will over heat and seize the motor. If this is the case, the motor will hum and kick the breaker. You may also have a ... more
2 Likes · 1 Answer
A:
Usually this is 20 inch, but you can raise the deck as long as the bottom of the tub is supported by the floor by shimming or a platform. The tub cannot hang by the flange unsupported. Your deck must be at least as high as indicated on your Izzi ... more
2 Likes · 1 Answer
A:
There are many good reasons! Medical: Hydrotherapy has been proven to be one of the best and most effective forms of relief for certain medical conditions such as muscle and joint pain, back and neck aches, sprains, stiffness, and other minor ... more
2 Likes · 1 Answer
A:
You may install an in-line heater on your Izzi unit after purchasing it; however, the heater must be an Izzi in-line heater to prevent voiding the warranty and the NAHB approvals on the jetting system. ... more
...