Filter by tags
Questions, Articles and Polls
2 Likes
·
1 Answer
A:
The Internal main gear on the right side of the reel is an enclosed gear which does not allow access to the end of the spool shaft from the right side. The end of the spool shaft is accessible on the left side so the tension adjustment is placed in
... more
2 Likes
·
1 Answer
A:
Yes. Click Hazards of Knob and Tube Wiring for a detailed overview.
... more
2 Likes
·
1 Answer
A:
Axons often have thousands of terminal branches, each ending as a bulbous enlargement, the synaptic knob or synaptic terminal.
... more
2 Likes
·
1 Answer
A:
There is usually a coarse focus and a fine focus knob. The fine focus allows you to make fine adjustment in focus.
... more
2 Likes
·
1 Answer
A:
The RAT pedal’s filter control is a variable low-pass filter that allows a selective high-frequency cut after the signal has been amplified, equalized and limited by the distortion circuitry, thus allowing the control over the higher-order
... more
2 Likes
·
1 Answer
A:
If you turn the Dosage Knob backwards to correct a mistake, it will not damage the Pen, but you will lose some medication from the FOLLISTIM AQ Cartridge (follitropin beta injection). If, by mistake, you dial past the correct number, do not try to
... more
2 Likes
·
1 Answer
A:
The Range knob affects both the way attacks sound and also limits the total depth of compression to give a more natural sound. The range set at full is good for limiting applications or if you want loads of pumping when using an external sidechain
... more
2 Likes
·
1 Answer
A:
Depending on the model of the compressor you can set the Range to -78 dB for modern units with 18 V power lines for the sidechain, or to -65 dB for older units with 15 V power lines.
... more
2 Likes
·
1 Answer
A:
It is not necessary to totally remove the knob from the slide assembly when adjusting the pad. However, if the knob should become unattached from the assembly, check the tubing to be certain the metal insert is aligned for the knob to fit. If you
... more
1 Like
·
1 Answer
A:
This is an Address Switch that sets the ID number (board address) of the Light Controller in question. Other items on the Light Controller are detailed in the Hardware Wiring Information file in the Technical Support section of our website.
... more
1 Next