Filter by tags
Questions, Articles and Polls
1 Like
·
1 Answer
A:
This is normal for the output of this device, as the output waveform is a modified sine wave. 81-85 VAC is the RMS valule of a 110 VAC sine wave, and you will read aound 85 to 95 volts when measuring with a conventional Average Responding Multimeter.
... more
2 Likes
·
1 Answer
A:
Connect in series for current and parallel for voltage measurement. Note that since what you are measuring is actually the combined resistance of your resistor and the meter, you should use a low-resistance meter for current measurements (so that
... more
1 Like
·
1 Answer
A:
Jeff Luszcz's MacMultimeter will display readings from a Radio Shack digital multimeter with PC data interface (Cat No 22-168A) connected to your Mac's serial port.
... more
1 Like
·
1 Answer
A:
No, analog capacitors are not accurate. Use a digital capacitance or ESR meter to test capacitors.
... more
1 Like
·
1 Answer
A:
To read an analog multimeter once you hookup the testing probes to what you are testing the analog dial will show a reading. If it is reading voltage it will show the voltage amount. You can find more information at http://www.doityourself.com/stry/
... more
1 Like
·
1 Answer
A:
If I play Evil Presents giving my opponent Phyrexian Negator, and...
... more
2 Likes
·
1 Answer
A:
Selecting the right Fluke multimeter will depend on your situation. On the higher end are the infrared meters, which can be used to detect currents without any attachments. These are beautiful instruments, handheld and intuitive to use. They
... more
2 Likes
·
1 Answer
A:
When they fail immersion heaters will often crack, with the heater installed, all of the wiring disconnected and using resistance scale test from connection point to ground, if you get any reading other than open the heater has failed. Then do a
... more
2 Likes
·
1 Answer
A:
You can use your multimeter as an ohmmeter to test the capacitor. • Put your multimeter in the high ranges 10K-1M • Connect multimeter to capacitor leads (Observe the polarity if electrolytic). As soon as the leads make contact, the meter will
... more
2 Likes
·
1 Answer
A:
There should be 4 function on the average multimeter:Volt meter, current meter, resistance checker and continuity check. They will normally be selectable by a main dial or menu. Both AC and DC voltage and current can be measured. The volt meter
... more
1 Next