I'm making some bowls for a gift with PET bottles and I was wondering if there's a way to dye the PET, well an easy way, the homemade kind. I did a little research and basically found out that it can be done industrially with some expensive ... more

Geogrid products fabricated from high density polyethylene or polyester yarns encapsulated in a protective coating specifically fabricated for use as a soil reinforcement material are acceptable geogrid product substitutes to the specified geogrid. ... more

High-density polyethylene (HDPE) is used to make many types of bottles. HDPE has good barrier properties; it's well suited for packaging products with a short shelf life and has good chemical resistance. It is identified with the number 2. HDPE is ... more

Although all JAZ Products polyethylene fuel cells exceed SFI SPEC 28.1, only the fuel cells labeled “THIS FUEL CELL CARRIES SFI CERTIFICATION” are actually certified. Only the fuel cells that are specifically designed for classes that require SFI ... more

There are a variety of methods for producing Polyethylene wax. Polyethylene wax can be made by direct polymerization of ethylene under special conditions that control molecular weight. Another method involves breaking down high molecular weight ... more

Polyethylene tanks have lower cost than stainless steel or fibreglass. Lightweight - less than one-half, the weight of steel. Seamless construction, for easy cleaning and leak proof service. Exceptional Impact resistance Polyethylene has longer ... more

Polyethylene waxes can be supplied in many forms. The can be supplied in bulk with the use of specialty bulk trailers that are heated. Polyethylene wax can be finished as a prill, or atomized powder. Polyethylene waxes can also be ground into ... more

Very fine aluminium foil serves as a barrier to light, aromas, and oxygen, which enables the contents to last for months without preservatives or refrigeration. The polyethylene acts as a water-tight barrier. It is this resource-efficient ... more

I have an Old Town canoe that needs a bit of exterior skin repair. This canoe uses Crosslink 3 Polyethylene. Can I repair the skin with epoxy resin if I treat the skin with a torch first? I've heard that the heat treatment allows adhesives to stick ... more

Garbage bags are produced using a two-stage process: extrusion and conversion. In extrusion, the resin (in the form of beads) is melted to temperatures exceeding 200 degrees Celsius to a uniform material which is then blown upward (in this stage ... more