Filter by tags
Questions, Articles and Polls
2 Likes
·
1 Answer
A:
Recol®’s AntiCorrosive contains zinc base raw materials that provide a barrier against the moisture, protecting the metallic surface from the corrosion and extending its useful time life.
... more
0 Likes
·
1 Answer
A:
Recol®’s AntiCorrosive can be applied on any porous surface, whenever the surface is clean, dry and free of dust, dirt, grease, oxide, loose particles, contaminant agents and paint deteriorated. Recol®’s AntiCorrosive can be applied directly on
... more
0 Likes
·
1 Answer
A:
Initially, it should be mixed in a proportion 1:1 (for example, 1 gallon of Recol® Glaze with 1 gallon of water base paint), but this proportion can vary in agreement to the open time and the final hiding power of the film. More the hiding power,
... more
2 Likes
·
1 Answer
A:
Recol® Glaze, unlike PVA, contains special fillers and additives that make Recol® Glaze works as primer of vinyl paints and extends the open time of water base products.
... more
2 Likes
·
1 Answer
A:
Both products are water base emulsions, but the difference between PVA- Acrylic and PVA-Vinyl acrylic is in the composition. PVA- Acrylic is made of styrene and acrylic-ester copolymers, while PVA- Vinyl acrylic is made of vinyl-acetate and acrylic-
... more
0 Likes
·
1 Answer
A:
Like other stuccoes, Venetian Recol® Plaster can be applied in any surface whenever it is porous, clean, dry and free of dust, grease, loose particles, contaminant agents and/or moisture. Since this point of view, Venetian Recol® Plaster presents
... more
2 Likes
·
1 Answer
A:
In the case of surfaces that have enamel, gloss paint or waxes, it is necessary to sand very well the surface to generate adhesion points, withdraw the dust and clean. For additional details, see the section: Application Techniques.
... more
2 Likes
·
1 Answer
A:
No. If the decorative stucco that is in the base is already shone or has a wax, it is compulsory to sand perfectly the surface in order to generate points of adhesion.
... more
2 Likes
·
1 Answer
A:
The yielding of Venetian Recol® Plaster is between 4-6m2 by gallon. This practical yielding depends on the type of surface to work, the complexity of the work to carry out (design and number of coats required for such design) and the ability of the
... more
2 Likes
·
1 Answer
A:
Venetian Recol® Plaster can give shine, semi-shine or flat finishes according to the requests of your decoration. To enhance the shine of the final film, it is recommended the use of Recol® Wax.
... more
1 Next