Filter by tags
Questions, Articles and Polls
2 Likes
·
1 Answer
A:
Routing Tables Defined A routing table is a collection of information on where a network is located in reference to the router the table is in. Routers can have one or many ports, and each port can access many different networks. The routing table
... more
1 Like
·
1 Answer
A:
• Built-in NAT firewall security • Simultaneous Internet access for up to 250 Internet devices on the in-home LAN using only one WAN IP address • Wireless operation at 11, 5.5, 2, or 1 Mbps • Wireless operating range of up to 330 ft. (11 Mbits/sec -
... more
2 Likes
·
1 Answer
A:
Yes, a wireless print server will do the trick, effectively converting a standard USB-only printer to a wireless printer. Some printers, like my HP Officejet Pro L7780 have wireless capability built in, so they can connect directly to a wireless
... more
2 Likes
·
1 Answer
A:
A. Any Compatible Systems router with multiple WAN ports and no internal CSU, which includes the 2600i, 2800i, 2900i, 3400R, 3500R, and 3800R can be configured for such a scenario. Each WAN port can only be configured to dial-up to one remote
... more
2 Likes
·
1 Answer
A:
The HWR54G provides users with several levels of security. Depending on which level of security you wish to set please follow the appropriate instructions below. WEP is an older security standard than WPA. For the most up to date advanced security
... more
2 Likes
·
1 Answer
A:
There is a bug in a version of the firmware for the DLink DSL-504 ADSL router (and some Netgear routers) which causes the NAT routing table to discard any entries for TCP/IP connections which have been idle for 5 minutes or longer. If you are
... more
2 Likes
·
1 Answer
A:
Yes, the antenna can be removed and replaced or upgraded. The connection method is, Reverse Polarity Sub-Miniture Adapter (RP-SMA), is readily available at most computer or electronics stores.
... more
2 Likes
·
1 Answer
A:
A. A maximum of three repeaters are allowed to repeat the wireless signal from the WRVS4400N.
... more
2 Likes
·
1 Answer
A:
The following example creates 2 aggregates and suppresses any more specific addresses that may be contained within those aggregates. The access-list causes only those nets to be distributed as listed, and not any others that may exist in the BGP
... more
1 Like
·
1 Answer
A:
The ADSL X5 integrates a full-rate ADSL modem, router, NAT firewall, four-port 10/100 Ethernet switch and a USB port into a single cost-effective product. Concurrent Ethernet and U...
... more
1 Next