Filter by tags
Questions, Articles and Polls
2 Likes
·
1 Answer
A:
Prices vary widely from one slide chart project to the next because almost every order is custom designed and custom manufactured. In general, there is a one-time fixed set-up and prep cost of roughly $1500.00. After that, the unit price ranges
... more
4 Likes
·
2 Answers
A:
A. Yes, because of the revolutionary track and wheel design, the enclosure requires only two people to open or close in a matter of minutes.
... more
2 Likes
·
1 Answer
A:
The slide switch on the PCM400 Interface/Terminal board will interrupt the main power to the PCM's boards and outputs. Back to Top My Problem is... Why can't I connect properly to a PCM400 using a Modem? If the computer you are using does not dial
... more
2 Likes
·
1 Answer
A:
Yes. However, depending upon the manufacture, some slight work maybe required on our slide stop lever. We have found that the different manufactures use different strength springs that push the plunger against the slide stop lever. If the spring is
... more
2 Likes
·
1 Answer
A:
Generally you need about 2-3'. Some manufacturers advice 5+' It is important to be sure the inflatables aren't going to slide around or make contact with anything which can cause damage or injury. This goes for the clearance on top of the unit as
... more
2 Likes
·
1 Answer
A:
You can use any type of slide on the market. When using epoxy coated (european type) slides, please attach the front hook dowel at a maximum of 37mm from the front of the slide.
... more
1 Like
·
1 Answer
A:
We recommend a double captive type slide for best performence. You may also use a single captive slide, but need to make sure that side clearances between tray and pilaster are to slide manufacturers specs in order to avoid the non-captive side
... more
1 Like
·
1 Answer
A:
Yes. This can happen if you have the "1:1 Aspect Ratio" checkbox selected in the IControl prefs editor--it interferes with Visual Prefs. Note that one of the earlier beta releases of CyberGraphX had this problem, so make sure you're using the
... more
2 Likes
·
1 Answer
A:
No, you don't need to cite a specific slide number for PowerPoint presentations, according to APA style. All you need is the author, the date, the title, and the URL if applicable.
... more
2 Likes
·
1 Answer
A:
Click the first slide to enlarge it. If the photos in this group are part of a slide show, there will be a button at the top of the page to the far right of the slide show title bar that will start/stop the slide show. (Not all photos are part of a
... more
1 Next