...

Filter by tags

Selected Tags


Questions, Articles and Polls

2 Likes · 1 Answer
A:
A-The amount of time it takes to complete a job depends on the size and detail requested by the customer. For a typical job we estimate one day for setting-up, one day for pouring, and one day for detailing and sealing. ... more
2 Likes · 1 Answer
A:
Typically these ID stamps are located on the starboard side (right as you face forward). Sometimes they are stamped upside down. On boats made by Thompson at Peshtigo, WI, these codes often times begin and end with a letter. Note that there was no ... more
2 Likes · 1 Answer
A:
A. Yes, provide a stamped structural analysis from a certified Maryland Physical Engineer regarding any changes your request may make upon the structure. Please provide this with your completed submission. Electronic Services will examine all ... more
2 Likes · 1 Answer
A:
OBC Table 9.12.2.2 shows the minimum depths of foundations (which shows depth of foundation to below frost, ie 3'-11") But OBC 9.12.2.2 (6) (b) (iii) states these depths don't apply for buildings "not more than 55 m^2 (538 ft^2) in building area". ... more
1 Like · 1 Answer
A:
This was the answer from the Maltese Authorities: The Residence Certificate issued in your respect by the Commissioner of Inland Revenue (CIR) to confirm that you may reside in Malta on a permanent basis needs to be reflected in your passport. This ... more
1 Like · 1 Answer
A:
Flights can be made with less than four days advanced notice but they must be stamped "Signed" by midnight the night they were entered into GovTrip - otherwise they will be cancelled. PLEASE NOTE: It is not required that they be "Approved" at this ... more
1 Like · 1 Answer
A:
I use extruded aluminum emission plates for ALL sub-floor hydronic radiant floor systems. Having used stamped plated, no plates (staple up, suspended, etc), and even tried the infamous (and nearly worthless) bubble-foil, extruded emission plates ... more
2 Likes · 1 Answer
A:
The difference is the metallurgical structure of the metal. The structure of a Casting is tiny beads of metal melted together; it tends to porous and has very little strength, and when bent can easily break. A stamped product is made from sheet, ... more
2 Likes · 1 Answer
A:
Yes, but there are several strong technical aspects that make the process of combining Iron and Synthetic Enamel very costly and fairly incompatible. First, Iron is the cheapest material and is commonly used to get a product of a lower quality at a ... more
1 Like · 1 Answer
A:
Sorry about that. The United States Postal Service now makes us... Actually, no. This one's your fault. You haven't checked out what MEDIA MAIL means. Sadly, it does not mean "CHEAPER ARTIST RATE". It means tapes (what are those?), floppy discs ( ... more
1
...