Filter by tags
Questions, Articles and Polls
2 Likes
·
1 Answer
A:
The amount of static is measured using an Electrostatic Field Meter. Z-Mar has a variety of Field Meters available. What range is Conductive and what range is Dissipative? The Conductive range is from 100 - 105. The dissipative range begins at 105
... more
2 Likes
·
1 Answer
A:
This is a question that we hear a lot. In general, there really are no advantages to using one or the other. If the DHCP server in your regional data center is functioning properly, the use of a dynamic configuration is strongly recommended. However,
... more
2 Likes
·
1 Answer
A:
A fan works much like a pump; it operates at a given volume AND static pressure. For example, 600 CFM @ 6". The relationship between the two is inverse - that is, as pressure drop increases, volume will decrease. But it is not a linear relationship.
... more
2 Likes
·
1 Answer
A:
The biogas produced by the SGBR can be utilized to replace natural gas or to generate electricity. The biogas or electricity can be tied into an already existing system for your use and/or sold to generate revenue.
... more
2 Likes
·
1 Answer
A:
Location: http://www.jguru.com/faq/view.jsp?EID=3354 Created: Dec 22, 1999 Modified: 2000-05-19 18:22:39.565 Author: Tim Rohaly (http://www.jguru.com/guru/viewbio.jsp?EID=10) Variables declared as static members are not considered part of the state
... more
2 Likes
·
1 Answer
A:
- No, the adhesive is not conductive. Conductive adhesives are not very aggressive. The peel and stick static control device uses an aggressive adhesive with a space at the top and bottom of the holder to allow the fibers to make direct contact
... more
2 Likes
·
1 Answer
A:
When water is not moving, the vertical distance (in feet) from a specific point to the water surface is the static head. (The static pressure in psi is the static head in feet times 0.433 psi/ft.).
... more
2 Likes
·
1 Answer
A:
There are two ways to model a single stage contactor: 1) three phase Separator, or 2) two ideal stage Column with the efficiency set to 1% for all components on one of the stages. The Column approach must be used if you want to model a single stage
... more
2 Likes
·
1 Answer
A:
All power supplies have a limitation on how many static eliminators they can power. This limitation is expressed as the maximum number of inches of static bar which a power supply can power. The calculation of number of inches is based on the
... more
0 Likes
·
1 Answer
A:
The license allows you to use your FindMe! Static map on several websites provided they all belong to the same owner. You cannot however, use it on a website that belongs to a non-related company.
... more
1 Next