Filter by tags
Questions, Articles and Polls
2 Likes
·
1 Answer
A:
Seek emergency medical attention if you think you have used too much of this medicine. Overdose symptoms may include feeling restless or nervous, dizziness, drowsiness, nausea, vomiting, diarrhea, stomach pain, loss of appetite, increased sweating,
... more
2 Likes
·
1 Answer
A:
The specific gravity of uPVC is1.4-1.45gm/cm3 where as that as steel has 8gm/cm. T aking the strength of the material into consideration the pipes are optimally designed to make them light without any compromise in its strength requirerments.
... more
2 Likes
·
1 Answer
A:
A. ACI 318-051 and ACI 301-052 require field-cured cylinder tests to determine if the concrete has reached the strength specified by the engineer for removal of formwork or shoring. The documents, however, also allow the use of alternative methods
... more
2 Likes
·
1 Answer
A:
A3: There are different modes for implementing Aesthetic Development. To continue the arts learning experiences at the junior secondary level and to further develop students' creativity, aesthetic sensitivity and critical responses to the arts,
... more
2 Likes
·
1 Answer
A:
Ans: The minimum required strength for 2 hours short session and for full day workshop is 200 and for special one week camp is 20 participants only.
... more
2 Likes
·
1 Answer
A:
There is no standard co-relation . One has to generate a site specific co-relation for each site/mix design.
... more
2 Likes
·
1 Answer
A:
+ What is meant by slump? + What are admixtures? + What are plasticizers? Will the strength of concrete be affected by the addition of these plasticizers? What is concrete? concrete is a composite building material made from the combination of
... more
0 Likes
·
1 Answer
A:
All are free actions. Strength of the bear can be used 1/day.
... more
2 Likes
·
1 Answer
A:
While it is hard to say without doing a thorough assessment and knowing their current training schedule, we typically recommend that an athlete is training 3-4 times per week, depending on which part of their season he/she is in. We recommend at
... more
2 Likes
·
1 Answer
A:
I assume you're talking about a coil of wire, or a solenoid. Draw a rectangular Amperian loop where one of the sides lies on the axis of the coil (goes through its center). You can then use Ampere's law. integral B ds = N*mu*I where B = magnetic
... more
1 Next