Filter by tags
Questions, Articles and Polls
2 Likes
·
1 Answer
A:
A. We recommend 3cm because it is thicker than 2cm and does not require a plywood base under it to support it. 2cm also requires lamination of the edge which makes a seam and isn't as beautiful. Since the cost for 2cm material in our area (Midwest)
... more
2 Likes
·
1 Answer
A:
The thickness of sheeting is normally measured as its BMT (base metal thickness). For steel of the same grade and profile, a higher BMT generally means the sheet can span further between...
... more
2 Likes
·
1 Answer
A:
Endometrium is the lining on your uterus. If your lining is 68 cm that means you have a lot of lining and you should be checked. The regular amount is only 1-2 centimeters. ChaCha on!
... more
2 Likes
·
1 Answer
A:
A. The thickness tolerance will vary depending on the thickness of the product. Consult the data page for the specific product for this information. Acrylic foam tapes have a width tolerance of + 0.015 inches (+ 0.38 mm). Back to Top of Page
... more
2 Likes
·
1 Answer
A:
Manufacturers use aluminium in legs and truss bars between 1.0mm and 2.0mm thick. Thicker aluminium will offer greater strength and stability. Extreme Marquees uses 2mm thick aluminium in legs and truss bars. Our truss bars are also reinforced with
... more
2 Likes
·
1 Answer
A:
Hulls: The common mining thickness applied is 50mm to 100mm and up to 150mm for structural support. Specifications vary, for example, from average 50mm cover to minimum 50mm cover. Our recommendation is that minimum cover is always specified. Note
... more
2 Likes
·
1 Answer
A:
¼" thick glass is what is used for the all glass door on the Laatu sauna.
... more
2 Likes
·
1 Answer
A:
Ovarian dysfunction is the most likely cause of abnormal bleeding in women pre-menopausally, but pelvic pathology is also common. The likelihood of finding particular pathology would depend on the bleeding disturbance. In one study, out of 500
... more
2 Likes
·
1 Answer
A:
NandaR. ; GoodchildL. ; GambleA. ; RanganA. ; and CampbellR.S.D. Background: Prevalence of rotator cuff tears increases with advancing age (Ellman et al). In spite of proximal humeral fractures being common in the elderly, the influence of a
... more
2 Likes
·
1 Answer
A:
A memory foam layer thinner than 3″ will not provide a great level of comfort. Anything below about 4.5lbs/cubic foot will wear out quickly. Novosbed memory foam is 4″ thick at 5.2lbs/cubic ft density.
... more
1 Next