Filter by tags
Questions, Articles and Polls
2 Likes
·
1 Answer
A:
Solar tower technologies and some parabolic trough technologies have a working temperature of 600 C. Other technologies work at 270 C.
... more
2 Likes
·
1 Answer
A:
The simple answer is this depends on which make and model you choose, but most Micro Wind Turbines are built to last 10 years before any serious maintenance. At eco-nex we supply all the main forms of micro wind turbine, from low-spec mass-produced
... more
1 Like
·
1 Answer
A:
Wind turbine blade design is a very important chapter to insure an efficient and properly designed residential wind generator. You need to figure out the wind turbine cost and make sure you can afford to design it correctly, or it is not worth
... more
2 Likes
·
1 Answer
A:
This contains the key components of the wind turbine, the gearbox and the electrical generator. Service personnel can enter the nacelle from the wind turbine tower.
... more
1 Like
·
1 Answer
A:
The Ettridge Wind Generator can have a Gemini Electric Generator incorporated in the base of the turbine, in line with the main shaft. The Gemini Electric Generator website is : www.geminielectricmotor.com It is possible to run a gearbox off the
... more
2 Likes
·
1 Answer
A:
Turbine engines are somewhat misunderstood. Although many people use the term interchangeably with "jet engine," the fact is that they're related but not necessarily the same thing.DefinitionA basic turbine engine is one that extracts the the
... more
1 Like
·
1 Answer
A:
Modern blades range between 20-40 meters on average. The first utility grid-connected wind turbine (UK) had an 18 meter diameter.
... more
1 Like
·
1 Answer
A:
The Ettridge Wind Turbine is the only wind turbine that can operate at ground level, simply because it works on a sail, spinnaker principle, and as we all know sailing ships and yachts work at sea level. Naturally the clean air movement and
... more
2 Likes
·
1 Answer
A:
Wind turbine blades are the key to a windmill’s optimal power output and the part of greatest diversity involved. Although the generator can vary widely based on the size of the installation, a single wind turbine design can be fixed with any
... more
0 Likes
·
1 Answer
A:
It will utilize three different turbines. The high pressure (HP) turbine will be a steam-type turbine operating at 1000 F. The intermediate pressure (IP) turbine will be a modified GE J79 operating at ~1700 F (with a re-heater but without a
... more
1 Next