Filter by tags
Questions, Articles and Polls
1 Like
·
1 Answer
A:
Because of the cost and market concern, multiple-output S.P.S. usually only has one control (feedback) loop. Since Q-60B uses +5V channel as the control target, if there's heavy load at the +12V channel, the output voltage of the +12V channel will
... more
2 Likes
·
1 Answer
A:
No. The bed is fully insulated for complete safety under any circumstances. The motor also features a mechanism to prevent electromagnetic fields when not in use.
... more
2 Likes
·
1 Answer
A:
The Bahamas uses standard North American 120-volt/60-cycle AC electrical current. You will be able to operate American or Canadian appliances without adapters.
... more
2 Likes
·
1 Answer
A:
That depends on what you mean by "higher voltage". Nearly all "12 volt" panels are actually around 17 volts when working. But lately we have seen a couple of places touting their "high voltage" (on the order of 21 to 23 volts) panels on the premise
... more
2 Likes
·
1 Answer
A:
Power Factor Correction Devices are not touted as surge arrestors or Transient Voltage Surge Suppressors (TVSS) TVSS duties are best left to actual devices built for that purpose. The VC unit does perform some filtering duties but only when the
... more
2 Likes
·
1 Answer
A:
Dual Voltage allows selectable charging capability, offering a standard 13.6V "float" charge and a stepped-up 14.2V "bulk" charge for 12V systems. Increasing the float charge to the bulk charge allows for faster charging of the battery.
... more
2 Likes
·
1 Answer
A:
The pressure sensor in the Transducer bell is encapsulated in epoxy resin and is completely water proof. The operating voltage of the sensor, depending on the liquid level, is between 0.2 to 4.7 volts.
... more
2 Likes
·
1 Answer
A:
No, though they do handle the most frequent and destructive ones. More sophisticated technologies (i.e. hybrid powered conditioners and uninterruptible power systems) are on the market to handle complex power problems. Is there a guarantee? Our
... more
1 Like
·
1 Answer
A:
The voltage optimisation of The Ark can be set at tappings of 6%, 8% or 10%. In Australia, the statutory minimum voltage is 216V, hence the voltage optimisation cannot be set to reduce the voltage below this level. Assuming a typical voltage of
... more
1 Like
·
1 Answer
A:
If you own a car a voltage regulator is a necessity in order for the car to start and for lights for example to work on it and here is how a voltage regulator works. The voltage regulator controls of course the voltage that is produced by the cars
... more
1 Next