Filter by tags
Questions, Articles and Polls
2 Likes
·
1 Answer
A:
Cross leakage through the energy recovery wheels ranges from 2% to 5% between the supply and exhaust air streams. This amount of cross leakage is minimal and in comfort ventilation applications is perfectly acceptable. These leakage rates are also
... more
2 Likes
·
1 Answer
A:
The energy wheel preconditions fresh outside air before it is introduced to a building. The system can easily be tapped into an existing ventilation system. A portion of the air that would normally be recirculated through the system is exhausted
... more
2 Likes
·
1 Answer
A:
A front wheel drive vehicle has the power from the engine transmitted direct to the front wheels.
... more
2 Likes
·
1 Answer
A:
By: Mike Manges Fewer respondents to MTD's 2007 Custom Wheel Survey reported they're selling custom wheels than respondents to the same survey in 2005. Independent tire dealers know that selling custom wheels can be a lucrative niche if you possess
... more
1 Like
·
1 Answer
A:
It takes experience nothing a guy in the backyard can do... you either need the tools or find a shop that can replace the bearing for you if you take them the spindle and bearing and you might save some bucks but it will just take longer...
... more
2 Likes
·
1 Answer
A:
Prices vary widely from one slide chart project to the next because almost every order is custom designed and custom manufactured. In general, there is a one-time fixed set-up and prep cost of roughly $1500.00. After that, the unit price ranges
... more
4 Likes
·
2 Answers
A:
The hub assembly includes the wheel bearing. In nearly all cases, the bearing will be already installed in the hub. Also, I suggest http://mibearings.com for new wheel hub assemblies. Fill out the form on the front page. Good Luck!
... more
2 Likes
·
1 Answer
A:
No. This course is now required to be offered as a semester long course.
... more
2 Likes
·
1 Answer
A:
A new ordinance, passed October 31, 2006, has amended the City code to extend the motor vehicle registration fee to anyone living within a tax district that is (wholly or partially) within a three-mile radius of the City limits.
... more
2 Likes
·
1 Answer
A:
Yes, it was designed specifically for salt water! It is made of the best available corrosion-resistant aluminum -- combined with strength, and then clear-annodized for maximum protection. All pins and mounting hardware are stainless steel --
... more
1 Next