How do I assemble and disassemble my collapsable hoop?
Your collapsible hoop will arrive coiled down. In order to take the hoop out of its coil, stand it upright with connection area on top. Pull the two ends apart by pushing down slightly and pulling on each side of the connection area. After the hoop is separated, unravel the hoop to full size. The connector will be lodged permenantly inside one side. Simply push the end which is open over the connector until snug. There is electrical tape provided on one side of the connector. Unwind this tape and reapply it over the joint in a criss-cross fashion. You are ready to hoop! To collapse the hoop again, remove the electrical tape (which can be reused). Pull both ends of the hoop down to coil it about half way. Then flip the hoop over onto the floor and place your foot gently on the partially coiled hoop, holding it down. Pull the two loose ends up and around in a circle, reaching the ends together again. Reconnect the joint by pushing down slightly and connecting the ends. Now you and your h
