How do I Assemble my new SeaBright inflatable boat ?
• Your boat has several main inflation valves. Use them to inflate the boat approximately 20%. It should now have its general shape but should still be very “saggy”. This can be accomplished by using the manual pump that is supplied with the boat, with a 12 volt electric pump, or with a shop vac. • If your boat is a RIB, please skip down to the section that instructs you to install your seats. • If your boat is equipped with an Aluminum Floor, Install it as follows ….. • Install piece number “1” into the nose of the boat (number up). Make sure that you push it as far forward as possible. If you are having difficulty then perhaps there is too much air in the boat. • Install the remaining pieces in number order except for the last one (rear most piece). • Install the last piece. To do this hold the rear edge of the second last piece up about 10 inches. Fit the last piece into the groove of the second last piece and then push them both down so that they “snap” into place making sure that
