How Do You Install A Garage Pro 46 Sound Electronic Horn?
Installing a Garage Pro 46 sound electronic horn is pretty easy to install. So let’s get started. Just follow the steps below to continue. Once you get the horn, remove the mounting bracket. Don’t lose the bolts and nuts. Go to the fender wall. Drill some holes in it. Now screw the bracket in place using screws. Then reinstall the bracket to the horn. Now drill some holes in the firewall. Be careful not to drill any wires or drill through the stereo system. Install some rubber grommets into the hole to prevent the sharp metal from cutting the wires. Run some wire up to box inside the car. There’s a box that should come with the horn. Then run that wire to the engine compartment. Get some wire splice. Insert one of the wires into the splice and crimp it down. Insert the horn wire into the other end of the slice and crimp it. Crimp nice and tight to prevent electrical shorting. Install your microphone into the mic jack. Plug the power cable into the cigarette lighter and you are done. Ju