Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

Are the higher frequency CPUs ever required when purchasing a PMAC?

April 26, 2017CPUs Frequency pmac purchasing

0

Posted

Are the higher frequency CPUs ever required when purchasing a PMAC?

1 Answer

0

Posted

For Turbo , we would recommend the 100mhz CPU for: -more than 12 axes uncommutated, -more than 8 axes -Servo update rate over 8kHz -Block (programmed move ) or segment rates over 500 Hz Recommendations for the 160 MHz: -More than 24 axes uncommutated -More than 16 axes commutated -Servo update rate greater than 15kHz -Block or segment rates over 1000kHz -2 of the 100 MHz requirements simultaneously If there is any doubt, we recommend that the prototyping is done with the fastest CPU available, then try running it at lower speeds.