Can I get rid of the Averaging Limits Exceeded message and the box symbols it displays?
Yes. The averaging limits are mainly for points observed multiple times with RTK. In static processing where we are going to adjust the vectors to control, it is mainly a pain in theneck. From the Tools pull-down menu, select Project Management Right-click on the project of interest in the displayed list. Select Properties at the bottom of the dialog box and change the limits for automatic coordinate averaging to some higher value, say 10 meters. Note: 10 meters is the largest value SKI-Pro will let you enter. This will give you a check on a bad starting position, but will not display the noise of processing from slightly different reference coordinates.
