Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

Can I run the dbx 260 AUTO EQ WIZARD sequence separately for inputs 1 and 2?

April 26, 2017Auto DBX EQ inputs run separately sequence Wizard

0

Posted

Can I run the dbx 260 AUTO EQ WIZARD sequence separately for inputs 1 and 2?

1 Answer

0

Posted

Yes, but you will need to set up a dual mono graphic EQ by entering CONFIGURATION mode. To perform this procedure, press and hold the PROGRAM/CONFIG button until the display reads CONFIGURE. Press NEXT PAGE to access the EQ section of the 260. If the preset already has a stereo graphic EQ (GEQ), press the data wheel inward and rotate to UNLINK as displayed by showing two seperate GEQ boxes. If one or both of the inputs have a PEQ as part of the processing, press the data wheel inward to choose SELECT and rotate the data wheel to select a GEQ instead. A PEQ (parametric eq) on the input path can not respond to the AUTO EQ sequence. Press NEXT multiple times to advance through all the processing blocks until the display reads “CONFIGURATION DONE, PRESS SELECT TO LOAD”. To LOAD, press the data wheel inward and press store 4 times to advance and store the configuration. The AUTO EQ WIZARD will now allow you to “Pink” each side separately.