Can the controllers two outputs be combined to drive a single load at twice the Amps?
Yes. However, this requires a different wiring of the controller which must be set at the factory. This version of the controller is a special order. Price is the same as the standard version. Regeneration FAQ’s Does the AX2550 support regeneration Yes. Power will typically flow back into the battery during deceleration, or whenever the motor is spinning faster (because it is pushed, or inertia) than it would at the applied power level. Does all the regenerated power go back into the battery Unfortunately not. Some of the energy is lost in heat inside the leads and the controller. The amount of regenerated energy also depend on the switching ratio on the PWM stage. In the extreme case when PWM is at 0, the motor is essentially shorted and all the power is dissipated in the motor windings, wires and transistors. What happens if there is no battery During regeneration, current will try to flow back into the battery. If none is present, voltage at the controller’s main power wire will kee
