How can I communicate with the Cisco ONS 15454 through Transaction Language 1 (TL1) commands?
A. These three options help you to communicate with the Cisco ONS 15454 through TL1: • Cisco Transport Controller (CTC) (GUI interface) • Telnet session • The serial RS-232 port The maximum number of simultaneous TL1 sessions that the Cisco ONS 15454 supports depends on which software release the node runs. To determine the maximum number, refer to the How many simultaneous TL1 sessions can the Cisco ONS 15454 support? section of this document. Each TL1 option mentioned above is described in detail here: TL1 on the Cisco ONS 15454 by way of the CTC (GUI interface) Complete these steps in order to issue TL1 commands by way of the CTC (GUI Interface): • Open a browser (Netscape or Internet Explorer), and type the address of the node where you want to run TL1 commands. • Log in at the CTC window. The IP address at the title bar must match the IP address of the node where you want to run TL1 commands. • When you are logged in, click File located on the upper left-hand corner, then scroll t
Related Questions
- How is Cisco dealing with REACHs Article 33 obligation to communicate information on Substances of Very High Concern (SVHCs) identified in the Candidate List in products?
- What is the difference between the Cisco router IOS commands show cdp neighbor detail and show cdp entry?
- How can I communicate with the Cisco ONS 15454 through Transaction Language 1 (TL1) commands?