How can I prevent problems when using eMule P2P software?
There are several issues that might occur when using eMule P2P software and some routers (including some D-Link routers). Although we have seen several firmware releases that attempt to address eMule problems, they seem to persist and become frequent issues in the forum. The most frequent behaviors related to overloading are spontaneous reboots, gradually reduced performance, or a non-responsive router: •When KAD is used, the NAT table overflows and the router reboots. While some users have reported various improvements using various firmware versions, there is no certain cure except for not using KAD. •Under normal use, the router slows, locks, or reboots. You may turn off the router’s DNS Relay feature, which on later firmware versions is located on the “Home / LAN” configuration page. •When there are hundreds of connections, the router slows or reboots. You may configure eMule to maintain fewer simultaneous connections. Other frequent issues: •The file sharing network reports “Low I
