Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

How do I get Sbackup to work with NetWare 3.12/4.x?

April 26, 2017Netware

0

Posted

How do I get Sbackup to work with NetWare 3.12/4.x?

1 Answer

0

Posted

Perform the following steps to make the Sbackup utility work with NetWare 3.12/4.x: • Install the latest sbackx.exe update from the Novell Web site. • Make sure the correct disk driver and ASPI driver are loaded for the installed tape drive. • Add the following line to the startup.ncf file: Set Reserved Buffers Below 16 Meg = 200 • Add the following lines to the autoexec.ncf file: Load TAPEAI.DSK SCAN FOR NEW DEVICES Load TAPEAI.DSK Load TSA312 (for NetWare 3.12) Load TSA410 (for NetWare 4.1x) Load SBACKUP • Follow the screen prompts. For PowerEdge 51xx-XL, 4×00, and 6×00 systems, the tape drive is on the second AIC78x0 controller. For PowerEdge SP/XE or SP-2/XE-2 systems, the built-in NCR 53C810 controller requires the dfs311.dsk or dfs400.dsk drivers revision A02 or later from ncrscsi7.exe from Dell’s BBS (512-728-8528) or Web site (www.dell.com). NOTE: Sbackup does not support IDE tape drives.