How do I set-up Zone 2 using the internal amplifiers, and the Presence/Zone 2 speaker terminals on the RX-V2400?
Speaker Connection: • Unplug the power cable on the RX-V2400. • Connect the Zone 2 speakers to the Presence/Zone 2 speaker terminals on the RX-V2400. • Plug the power cable back into the RX-V2400. Setting up Zone 2 on the RX-V2400 remote • Set the [REC OUT/ZONE 2] dial on the front panel of the RX-V2400 to [SOURCE/REMOTE]. • Press the [DVD] input button. • Press and hold the [LEARN] button gently with a paper clip for 3 seconds. L: DVD and DVD will flash alternatively on the remote LCD window. • Press the [ARROW] to the right button until L: AMP appears in the remote LCD window. • Press the [UP ARROW] button until Zone appears in the remote LCD window. • Press the [LEARN] button to complete Zone setup. Amplifier/Receiver configuration: • Go into the Set Menu. (Instructions about getting into the Set Menu on page 48 of the RX-V2400 Owner’s Manual.) • Use the [ARROW UP/DOWN] button to select Manual Setup. • Press the [ARROW] button to the Right to enter Manual Setup. • Use the [ARROW] Do