Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

I want to build a custom Twincam and need to wire the ignition. How do I do it?

April 26, 2017build Custom ignition wire

0

Posted

I want to build a custom Twincam and need to wire the ignition. How do I do it?

1 Answer

0

Posted

Use the TC88-2P module. For the best results, use a wiring harness from a specialty after market manufacturer, such as Wires Plus, made specifically for the this type of application. If you elect to try making your own harness, the pin outs are the same on the unit as the stock model. At a minimum for the ignition, you will need to install a map sensor, crank position sensor and correct Twincam .5 ohm coil, or our Dyna DC6-6 coil.