It is impossible to assign IP address to WebCam Server with Ping command. What is the problem?
Ping command is only used on local network. With a PC or a notebook computer, you can assign an IP address to WebCam Server connected on local network with ping command or setup program. If you cannot assign IP address to WebCam Server with ping command, you should check under written 2 points. First, you watch the LED in the rear of WebCam Server. For accurate judgment, you disconnect and re-supply power to WebCam Server. WebCam Server has two LED of yellow and green in the rear. When you supply power to WebCam Server, green LED is on for two second then it is off. Afterwards it blinks once every two seconds. Yellow LED is on for 5-6 seconds after supplying power then it is got off. Afterwards yellow LED blinks continuously when it sends images. If green LED blinks once every four seconds, there is a problem at networking. Networking problem can be caused by bad network line and very rarely by LAN port of WebCam Server. In the situation, you check whether your network line works prope
