The water in the upper chamber of my Berkey system does not drain all the way. Is this normal?
Yes it is normal and not unusual for the last 1/2″ to 1″ of water to remain in the upper chamber. By design the water must pass through very fine micro pores within the elements in order to pass from the upper chamber to the lower. The lower the water level in the upper chamber, the lower the pressure available to force the water through the micro pores. You might have noticed that the system purifies much faster when full than when half full. That is because there is more pressure. The only way to remedy the problem would be to enlarge the pores within the filter elements. That would of course, reduce the efficiency of the purification elements. During each cycle the water left from the previous cycle mixes with the water from the current cycle and is then purified. You should not be concerned about the excess water during normal use however if you discontinue using your filter for a period of time such as during a vacation, it would not hurt to empty the upper chamber before departin
