We shall need cuttings large enough to contain fluids. Therefore what is minimum cutting size for MR-ML ™ Systemmeasurement?
We propose to measure on 1 mm-6 mm cuttings. The optimization of the drilling program can be provided (different bits) for exploration wells where wide range of information is important. This job was done for offshore wells in the Gulf. Q: For all these reasons, we believe that measurement cannot be done on a single cutting, but a group / mass of cuttings. How to prepare this mass of cuttings NOT to affect the NMR true measurement. Of course, measurements on one piece of cuttings (depends on its size) is impossible (S/N>1). As it is said above for an informative measurement you will need a cuttings sample container with a volume close to standard sample volume filled with cuttings. We provide our customers with detailed sample preparation procedure. Q: The comparison between Archimedes porosity and NMR porosity starts at 17% porosity and upwards, meaning a rather large amount of fluid is required to get a valid measurement. If true, it is not very promising for measurements on very sma