What is the advantage of using the USB data programmer with the Mapsource software and data card?
As mentioned in the previous FAAQ, only the area maps within the Mapsource software can be transferred to the data card via the USB programmer. These area maps contain a large quantity of information and are usually 6-8 megabytes each in size. You may either transfer the basemap to the data card through the USB programmer or direct PC to GPS connection through the PC cable that is supplied with the GPS. Transferring one area map to the data card via the USB programmer takes approximately 20-30 seconds. Transferring one area map to the data card via the PC connection as mentioned above can take as long as 20-40 minutes. Therefore, the USB data programmer saves a significant amount of time when transferring the area maps to the data card.
As mentioned in the previous FAQ, only the area maps within the Mapsource software can be transferred to the data card via the USB programmer. These area maps contain a large quantity of information and are usually 6-8 megabytes each in size. You may either transfer the basemap to the data card through the USB programmer or direct PC to GPS connection through the PC cable that is supplied with the GPS. Transferring one area map to the data card via the USB programmer takes approximately 20-30 seconds. Transferring one area map to the data card via the PC connection as mentioned above can take as long as 20-40 minutes. Therefore, the USB data programmer saves a significant amount of time when transferring the area maps to the data card.
Answer As mentioned in the previous FAQ, only the area maps within the Mapsource software can be transferred to the data card via the USB programmer. These area maps contain a large quantity of information and are usually 6-8 megabytes each in size. You may either transfer the basemap to the data card through the USB programmer or direct PC to GPS connection through the PC cable that is supplied with the GPS. Transferring one area map to the data card via the USB programmer takes approximately 20-30 seconds. Transferring one area map to the data card via the PC connection as mentioned above can take as long as 20-40 minutes. Therefore, the USB data programmer saves a significant amount of time when transferring the area maps to the data card.
Related Questions
- What could be the problem if I cannot seem to save Mapsource map data to the data cartridge via the USB data programmer?
- What can be saved onto the data cards when using the USB data programmer with the Mapsource CDs and GPSMAP 295?
- What is the advantage of using the USB data programmer with the Mapsource software and data card?