Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

What is the proper method for setting gain on an L1® Model I power stand?

April 26, 2017gain method model power setting stand

0

Posted

What is the proper method for setting gain on an L1® Model I power stand?

1 Answer

0

Posted

There are three gain settings for the primary channels (1 and 2) and two gain settings for the secondary channels (3 and 4). To set the gain for the primary channels 1 and 2: Adjust the input gain Set the trim for the individual channel at the back panel of the power stand. Supply a maximum source signal and watch the LED. When you start to see it flash red, back off slowly on the trim knob until it flashes green again. Adjust the channel gain with the R1 remote control With the master at zero, set the respective channel gain to 6. At this point, the LED on the remote will be at the same intensity as the LED on the back panel of the power stand. This is considered optimum gain. You then can add a bit more channel gain on the remote if it’s required. Set the remote master gain The remote master knob is the last stage of gain. This knob gives you control over all four channels of the power stand. To set the gain for channels 3 and 4 simply adjust the input gain of the individual channel.