Where can I find a free diagram/schematic for how to remove my 1991 Ford Ranger manual transmission?
Disconnect the negative battery cable. Remove the gearshift lever assembly from the control housing. Cover the opening in the control housing with a cloth to prevent dirt from falling into the unit. Raise the vehicle and support it safely. On 2WD vehicles, matchmark the driveshaft to the rear axle flange. Position a drain pan under the tailend of the transmission. Remove the driveshaft-to-rear axle flange fasteners and pull the driveshaft rearward to disconnect it from the transmission. Disconnect the clutch hydraulic line a the clutch housing. Plug the lines. Disconnect the speedometer from the transfer case/extension housing. Disconnect the starter motor, back-up lamp and, if equipped, neutral sensing switch harness connector. Place a wood block on a service jack and position the jack under the engine oil pan. On 4WD vehicles, remove the transfer case from the vehicle. Remove the starter motor. Position a transmission jack, under the transmission. Remove the transmission-to-engine re
