Can I Configure WAN Connection on Peplink Balance as Backup Only?
AlexS replied on May 18, 2010 20:06 // Yes, failover is fully supported in Peplink Balance besides link aggregation and load balancing. The kinds of WAN connection (DSL, Cable, 3G…etc.) supported are not limited, thus you can simply set a 3G or other kinds of connections as a backup. The only thing you need to do is configuring the WAN connection type and health check on the Web Admin Interface of Balance. Once your preferred connection is disconnected, the backup connection will come up. When the preferred connection come back to live, the Balance will simply shift back to use your preferred connection. Configuring Connection Type In order to configure WAN connection type to Always-on or Backup Priority, please follow the set up procedures below: • Go to Network > Interfaces > WAN > (preferred connection) and select Always-on as Connection Type. This WAN will then be your preferred connection. Illustration 1: Configuring WAN1 Connection Type as preferred connection Illustration 2: C
