How Do You Replace A Fuel Line In A Featherlite Weed Eater?
If your Featherlite weed eater is old or stored improperly, you may need to replace the fuel line. The most common problems on this trimmer are usually caused by bad gas in the lines or the carburetor. Keeping this line and the fuel filter clean will reduce breakdowns and increase the life of your trimmer. Fuel lines can be purchased on bulk rolls to reduce the cost. You should replace the fuel line on a regular, seasonal basis to keep the Featherlite running smoothly. Pour any remaining fuel into a container approved for fuel. Start the Featherlite and let it run until the engine dies. Use the Phillips-head screwdriver to remove the four screws securing the air filter cover, which is located next to the primer bulb. Remove the air filter from the engine and wash it in warm, soapy water. Locate the carburetor, which is behind the air filter and next to the primer bulb. Use the needle-nosed pliers to disconnect the top fuel line that’s connected to the carburetor. If you also need to re